RepRapFirmware 2.03RC4 available

[wilriker]

@dc42 Thanks. I'll try that - and I think I also how have a clue what's happening.

[Caveman]

Bed mesh level still the same issue as before. Z0 is all over the place. 2.02 works perfectly???

[dc42]

@caveman said in RepRapFirmware 2.03RC4 available:

Bed mesh level still the same issue as before. Z0 is all over the place. 2.02 works perfectly???

Is this with 2.03RC4 ? Are you getting any warning messages on the console?

Please provide a sequence that reproduces this issue for you, along with all the files needed to reproduce this (config,g, homing files, bed.g if used, and a very short GCode file to print if printing a file has to be part of the sequence).

[Caveman]

Whenever I have a wrong Z0 I get the message that the map has a substantial Z offset.....

Sometimes I have a proper Z0

[Phaedrux]

@caveman How are you homing Z and how are you establishing Z0 before running the mesh compensation routine?

[Gone2Far]

Had some odd leveling behavior on my delta.

Had a quite hard time getting G32 to converge on a particular height, but finally did. Then noticed several aborted probing points when running G29, followed by reports of 4.x mm max height error. After increasing the force needed by the smart effector from default to 128, got a kinda good height map. Now I have to edit the deflection setting in config.g--I had to add +0.15 mm baby step to get first layer correct. Everything was working quite well prior to upgrade.

[wilriker]

@dc42 said in RepRapFirmware 2.03RC4 available:

Meanwhile, as a workaround, try adding a M400 command at the end of stop.g.

I can now confirm that this solves the issue.

[Caveman]

Homing z happens by pressing home all. Establishing z0 happens by a papercheck.

[Phaedrux]

@caveman said in RepRapFirmware 2.03RC4 available:

Homing z happens by pressing home all. Establishing z0 happens by a papercheck.

Can you post your homeall and config files?

[dc42]

@wilriker said in RepRapFirmware 2.03RC4 available:

@dc42 said in RepRapFirmware 2.03RC4 available:

Meanwhile, as a workaround, try adding a M400 command at the end of stop.g.

I can now confirm that this solves the issue.

Thanks. This should be fixed in 2.03RC5, which I have just released.

[T3P3Tony]

Topic locked as RC5 is released:

https://forum.duet3d.com/topic/10786/firmware-2-03rc5-1-24rc5-released