Duet 2 Ethernet, BLTouch and double Zprobe leveling
escknx last edited by
I'm new to this, so please excuse my ignorance I may ask dumb questions.
I have Creative3D Elf corexy printer coming in a week and want to pre-configure Duet 2 Ethernet.
That printer comes with Marlin2 32bit board and uses their own developed double Z axis auto leveling.
According to manufacturer BLTouch is not supported on stock board because they use 2 x Zprobes for each axis motor in order to make this fancy auto leveling and there's not extra port for BLTouch.
I'm trying to figure out how to make this auto leveling + BLTouch work with Duet.
I'm looking into Duet's wiring scheme and I see one Z stop port in the midlle of the board, and another Z probe at the bottom.
So I connect BLTouch to Zprobe, but where other 2 stock probes go? Or 2 is max for Duet?
Veti last edited by
you dont need them for the duet.