To lite power
-
@Chrabban The first thing to check would be the voltage that the board is receiving. This is displayed on the web interface (Vin). If you heat the hot end, then run M122 it will show the min and max Vin.
-
found it, this dosent look good
Idle 11,9v
Only hotend 11,9v
Only heatbed. 10.7v
Hotend + heatbed 10,4v
Dont know idag my multimeter is wrong but it Said that it is 208v in the Wall and not 230 lightläsk that make a differnse as well ?
It is says that it can deliver 28A at 12v -
@Chrabban said in To lite power:
It is says that it can deliver 28A at 12v
post the picture of the definition on the power supply.
-
also older powersupplies that are not haswell compatible have a problem just suplying 12V without a load on 3.3V and 5V.
-
Here er go
https://www.techpowerup.com/review/corsair-cx430-v2/2.htmlThere you can fond morr information about it
seans like they got över 30A out of it during testning though -
It is 8 years Old so dont know how old it need to be for it to be a problem with being stable at 12v
-
-
So iaf i just Connect a raspbarry pi 3 it might fix it sens it uses 2.5A ?
-
give it a try.
-
I Will
tnx for the help, i might try i later today just got to find a micro USB that i dont need 
-
tom just made a video about it.
https://www.youtube.com/watch?v=5r-R3AgNJYc
