Bug G92 E0
-
Hey guys,
I have a dual extruder setup. I was at first just using the first Extruder and everything was working fine. Now I switched to the second one and right before a print starts, the extruder is doing a huge retraction. I changed no start g-code what so ever.
When I prime the extruder manually the Extruder position != 0. Now I wanted to set the extruder position to 0 with G92 E0. But no drive is set to 0 (even if the corresbonding tool is active). Only if I set another axis to Zero e.g. G92 Z0 or G92 X0 the Drive 0 and Drive 1 is jumping to zero aswell.Any advise?
Printer: custom delta
FW: 2.02RC5(RTOS) (2018-11-28b1)
Slicer: Cura 3.6Edit: Now when I set Z to 0 (before I put G92 E0) the drives are set to zero aswell
-
Edit: Its even more strange.
why is cura all of the sudden putting a retraction in the G-code?
;FLAVOR:RepRap
;TIME:903
;Filament used: 0m, 1.3913m
;Layer height: 0.2
;Generated with Cura_SteamEngine 3.6.0
T1
M82 ;absolute extrusion mode
M190 S75
M109 S220
G28M83 ;relative extrusion mode
G1 F7200 E-1
;LAYER_COUNT:101
;LAYER:0
G1 F1200 E-15
T1
M109 S220
M107And it is just doing that, when I put the Model on Extruder 2
On Extruder 1 everything is fine:
;FLAVOR:RepRap
;TIME:1356
;Filament used: 1.42583m, 0m
;Layer height: 0.2
;Generated with Cura_SteamEngine 3.6.0
T0
M82 ;absolute extrusion mode
M190 S75
M109 S225
G28M83 ;relative extrusion mode
G1 F7200 E-1
;LAYER_COUNT:101
;LAYER:0
M107
G0 F15000 X-8.991 Y47.4 Z0.2 -
Upgrade your firmware to 2.04. Release candidate is no longer supported when the full release is issued.
3.6 is a quite old version of cura by now as well...
Do you have cura set to use relative extrusion?
-
Never change a running system -- I will switch to 2.04 as soon as I find the time to do it proper ( I know its a lazy excuse but I want to read at least the release notes and the change log to know the new features)
3.6 ist the last one without the new interface (which I really don't like)
Yes its set to relative extrusion. (I actually can't remember if i put it that way). What is recommended?
After some more digging I found a clue:
https://github.com/Ultimaker/Cura/issues/3849There is a default retraction on tool change I will switch that one to zero
-
Ah yes, the new interface takes some getting used to. There are a few plugins that make it behave more like the old style that make it not so bad.
Relative extrusion is preferred.