Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Stepper motors

General Discussion

2

2

414

Log in to reply

Mikesplane last edited by

Hi, all what are the best stepper motors foe my DuetWifi? I dont seem to be able to find 24v ones. I have some from my old printer but are only rated at 1.4v
Mike
1 Reply Last reply
Reply Quote 0
T3P3Tony administrators last edited by

Check out:

https://duet3d.com/wiki/Choosing_stepper_motors

The stepper motors used are always well below the VIN voltage 1.4V is fine. The stepper drivers limit the the current flowing through the motors.
www.duet3d.com
1 Reply Last reply
Reply Quote 0

1 / 1