Bed minimum heating time.
-
@Dkos Glad it worked out for you. ( I drilled my hole very deeper than 4mm though.)
-
@dc42 said in Bed minimum heating time.:
M143
I think this is the solution I am looking for but I am not sure how you implement it. Right now I am only displaying the second sensor attached the the aluminum and waiting for them to match visually.
So I have this in my config:
; Main Board M308 S0 P"0.temp0" Y"thermistor" T100000 B3950 A"Bed" ; Silicone Pad M308 S5 P"0.temp1" Y"thermistor" T10850 B2900 A"BedT" ; Thermal Lug M950 H0 C"0.out0" T0 ; Bed. H = Heater 0, C is output for heater itself, T = Temperature ;*** Max Temp *** ; Main Board M143 H0 S130 ; Set maximum temperature for bed to 130C sensor (defined above)
So I would rather make the heater using the Thermal lug attached to the aluminum, but I am not sure how you use the center sensor to limit how hot the pad can get while heating the plate. You cant assign both senors to the heater can you?
This might be where virtual heaters come into play but I understand those even less.
-
@Miasmictruth This may explain better how to use it in RRF3+
https://duet3d.dozuki.com/Wiki/Gcode#Section_M143_in_RRF_3_01RC2_and_later