Firmware 3.0 and 2 Simple FilamentSonsors

[CupaCabra]

Hello, i have connected 2 Simple Filamentsonsors on my Duet3D Board. The Led‘s shows On/Off when I take the Filament into the Sensors but i don’t have a Status Massage in the Webbrowser.
The Trigger always shows that is no triggert.

I use the E0 and E1 endstops

Config.g

M591 P3 C"e0_stop" S1 ; filament monitor connected to E0_stop

What’s going wrong.

[droftarts]

@CupaCabra You need a 'D' parameter, related to the extruder drive each filament sensor is connected to. If 'D0' is your first extruder drive, your command would be M591 D0 P3 C"e0_stop" S1. Then you can get the status of the filament sensor with M591 D0.

See https://duet3d.dozuki.com/Wiki/Gcode?revisionid=HEAD#Section_M591_RepRapFirmware_Num_3

Ian

[CupaCabra]

Thx 4 the fast helping I wil Do the test tomorrow and report.

[CupaCabra]

Thx, it works
Awesome