Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Parts cooling fan control

Locked

Tuning and tweaking

2

3

632

Log in to reply

undefined

FrankNPrinter
last edited by

I have my parts fan set to auto and it cuts no and off a lot. only problem is it seems to be a couple seconds behind what the printer is doing IE starts to bridge then fan comes on 2-3 seconds later. any way to adjust this or do i have to go manual control for that?
1 Reply Last reply
Reply Quote 0
undefined

elmoret
last edited by

The slicer defines that, not the Duet.
1 Reply Last reply
Reply Quote 0
undefined

FrankNPrinter
last edited by

will look there too thanks!
1 Reply Last reply
Reply Quote 0

1 / 1