Duet 2 wifi not homing and other issues
-
Keep in mind the visualization is exaggerated. The actual tilt is only 1.2mmish.
I'll have to take a closer look a little later. -
ok let me know if you want any more files.
-
Ok i can say this for real. The mesh compensation doesnt work worth a darn. If it did the tip would be the perfect distance from the bed to get the perfect first layer not jam the nozzle. And cause the filament to not flow.
-
Ok how the heck does the bed switch from front being high to the side being high? in just one restart at that.
-
What does your mount look like?
Did you remeasure the XY offset after changing the mount?G1 X63 Y35 F6000 ; go to first bed probe point and home Z
G30 ; home Z by probing the bedChange the X Y position to move the probe to the center of the bed.
Have you manually leveled the bed to confirm the bed is touching the nozzle at all the leveling screw points?
-
its a tronxy x5sa pro its got a flat bar with the lead screw and two smooth rods running through it on each side and square stock running to each flat bar on both sides of the hotbed. Yes i have leveled the bed and made sure its touching at all points. So far i have gotten it to print its on layer 10 with your help 99% of the way lol the last 1% is from a random youtube post that talked about m500 to save everything which none of the documents talk about. thankfully when i found the m500 i setup everything saved with it and then reset the board and checked and m500 again just to make sure and it worked like a charm.
-
i think im gonna have to do a pully setup at the motors to fix any bed floppyness. But so far the semi fix is to not save power and to just let the motors have full power all the time.
-
The mount i got luckily kept the nozzle in the exact some spot and the probe is in the exact same spot as the original one aswell so woohoo gotta love luck.
-
M500 works a bit differently in Reprap than on an 8bit controller.
https://duet3d.dozuki.com/Wiki/Gcode#Section_M500_Store_parameters
Only a very specific range of things will be saved by M500. It's mainly used for saving delta calibration, PID tuning, and maybe some offsets.
-
I wouldnt know, this is my first 3d printer. I knew it didnt have any thermal runaway so i bought this board on the reccomendation of reviewers. But from what i have seen sofar is the software support for it sucks. The configurator doesnt even have a decent library of printers it only has a handful. If anything duet needs to get their act together on the library and start putting more in. And not rely on strangers to hopefully give them all of the info they need. This board and the configurator is still in alpha stage. Im gonna switch to a marlin based board since its has way more printers already in the database which also includes mine.
-
Sorry you feel that way. Good luck with the Marlin board.