Replaced heatbrake and nozzle, now Z offset does not work.
wickedracer last edited by
Cleaned my E3D V6 Hotend and replaced the nozzle, probably changing the overall length, but not by much and now when I go to use the Move Z on the PanelDue (to change the Z offset, closer to the bed), it doesn't change anything. what did I do that could've caused this? Any help would be great!
aidar last edited by
Probably your new nozzle is higher if you want to move it closer to bed. But you didnt probably change Z minimum, thats why it does not go lower.
If you're using a probe, you must redo this calibration.
If you're using an endstop, you may need to change your homeall if you use G92 Z to set the z height.