Minor firmware release 1.18.2

dc42

yes, 1.03-ch, all three files downloaded from site.

duetwebcontrol 1.15a
duetwififirmware 1.18.2
duetwifiServer 1.05-ch

I presume you mean 1.03-ch.

If you send M122 from a USB host program, what does it show as the wifi status?

brian

M 122 command; it reads;

Network
WifiServer is running
SPI underruns 0, overruns 0
===Webserver===
HTTP sessions: 0 of 8

dc42

I'm sorry, I forgot that M122 doesn't display WiFi stats in firmware versions prior to 1.19. To get the stats in 1.18 and earlier you need to send M552 S0 from USB to disconnect the network, then send M552 S1 and wait for the connect response.

brian

it now says; Wifi Server stopped

dc42

So you need to send M552 S1 to start it.

brian

says;
DuetWifiServer v 1.03(ch fork)
wifi vcc 3.14v, host name;
duetwwifi, reset reason: Turned on by main processor
Wifi is running as an access point with name
DuetWiFi

brian

but i cant connect using the ip address or the name duetwifi

dc42

If it's running as an added point then it's failed to connect to your WiFi network. You need to connect to it from a smartphone, tablet or laptop instead of to your usual WiFi router, to set up the SSID and password stored in the WiFi module. See https://duet3d.com/wiki/Configuring_RepRapFirmware_for_a_Cartesian_printer#Homing_Z_using_a_Z_probe and start in particular steps 7 to 10.

brian

Have obtained ip address on cell phone. There is no step for entering the SSID. Unable to make work.

brian

I think i'll just abort this procedure. I have a ir probe coming tomorrow. If i install that and then change firmware to the 1.19 beta, will i overcome the z endstop issue? Also having difficulty locating that download again. Do you have a link to it?

Thank

Dougal1957

Brian

Do you have anyone who lives near you that has the Duet boards that could possibly help you?

Where are you based?

Doug

brian

I'm in western Canada, not much help in these parts. My z probe arrived so maybe i'll have more success. Now if i can find that link to v 1.19 beta.

Dougal1957

@brian:

I'm in western Canada, not much help in these parts. My z probe arrived so maybe i'll have more success. Now if i can find that link to v 1.19 beta.

https://www.duet3d.com/forum/thread.php?id=1691