X an Y have changed after changing belt tension on delta

[Elvis0z]

Hey guys
I have just changed my carriages on my Anycubic Kossel so I can adjust the tension on the belts. I have noticed that now my X and Y have changed from 0 to X0.8 and Y-2.0 Z220.68. X and Y were both 0 before the change. Do I have to zero them and if so how would I go about this. I'm going through the Delta calibration guide but and am up to setting the trigger height and zeroing Z. Not sure about X and Y

Cheers

[Phaedrux]

@Elvis0z said in X an Y have changed:

I have noticed that now my X and Y have changed from 0 to X0.8 and Y-2.0 Z220.68. X and Y were both 0 before the change.

Where are you seeing this?

[Elvis0z]

Thanks fixed it was because I was setting up trigger height and it said to disable the command to lower the effector 5mm.

[Baenwort]

@Elvis0z so did disabling fix it or did not disabling fix it?

[Elvis0z]

@Baenwort I uncommented the line and all is good