@Baenwort I uncommented the line and all is good

Elvis0z
@Elvis0z
Best posts made by Elvis0z
Latest posts made by Elvis0z
-
RE: X an Y have changed after changing belt tension on delta
-
RE: X an Y have changed after changing belt tension on delta
Thanks fixed it was because I was setting up trigger height and it said to disable the command to lower the effector 5mm.
-
X an Y have changed after changing belt tension on delta
Hey guys
I have just changed my carriages on my Anycubic Kossel so I can adjust the tension on the belts. I have noticed that now my X and Y have changed from 0 to X0.8 and Y-2.0 Z220.68. X and Y were both 0 before the change. Do I have to zero them and if so how would I go about this. I'm going through the Delta calibration guide but and am up to setting the trigger height and zeroing Z. Not sure about X and YCheers
-
RE: Need to lower the nozzle
Well that clears that up. lol thanks for the info and the macro.
-
RE: Need to lower the nozzle
Do you have to to M501 at the end of the config.g. Ahhh just read the code in your macro
-
RE: Need to lower the nozzle
So I subtract what my baby steps are from the offset in config.g?
G31 P100 X0 Y0 Z-0.750
So I got a good layer coming down -0.35 so do I subtract that from Z-0.750?