Weird Tool Selection Behavior
-
So I have a large scale toolchanger and I have been trying to get all of my tool selection gcode tweaked to work really well, and now when I tested a tool selection, the machine goes through the tpre0.g as it should but then it doesnt actually change the state of tool 0 to active, and if I send another T0, it reruns the tpre0.g ... not sure whats happening here.
tpre2.g tpre1.g tpre0.g tpost2.g tpost1.g tpost0.g tfree2.g tfree1.g tfree0.g homez.g homey.g homex.g homec.g homeall.g config.g cancel.g bed.g
-
Running 3.1.1 on Duet 3 with 3 Tool boards and 2 external drivers
-
Just spitballing, is there a way to force a tool as active without running the tpre#.g files?