Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    Magnetic Sensor problems

    Filament Monitor
    2
    3
    54
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • BlueDust
      BlueDust last edited by BlueDust

      Duet2Eth still running on RepRap 2.X.... Will upgrade after I get my IDEX on a Duet3 working.

      It's been a long time since I have had major issues with my Magnetic Sensor and as of last night it's flipping out. Printer pauses every 30 seconds saying too little movement without saying result from sensor to make adjustments. When checking status of sensor it says no results as it hasn't moved enough Filament. After a lot of playing, it randomly finally displayed data and it doesn't make any sense.
      PXL_20201111_060926889~2.jpg

      Fun, that 3 letter word with "u" in the middle.

      1 Reply Last reply Reply Quote 0
      • alankilian
        alankilian last edited by

        What pattern are you getting on the green/red LED?

        If you manually feed some filament through the sensor, what does the LED pattern look like?

        "No Data Received" is an indication that you have a wiring problem.
        Did something get jiggled loose?

        SeemeCNC Rostock Max V3 converted to V3.2 with a Duet2 Ethernet Firmware 3.2 and SE300

        BlueDust 1 Reply Last reply Reply Quote 1
        • BlueDust
          BlueDust @alankilian last edited by BlueDust

          @alankilian
          It quickly flashes green when printing so I assumed it was working... It always says no data until after about 30 or 60 seconds (enough Filament has gone through the sensor). It's currently pauses before it has a chance to get through that much filament. And when it pauses it doesn't show the sensor status on the console. Just shows an error for not seeing enough movement and says paused.
          I will check the wiring as it makes sense to think one wire may have been slightly pulled loose.

          Thanks! I will look at it tomorrow and follow up. (Printing now)

          Fun, that 3 letter word with "u" in the middle.

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA