Enstop 24v

Amagatth

Hi all,

I have npn 12/24 sensor for x/y and I want know if anyone have already connect it on the duet 3?

I can put brown and blue on the Vin for the 24v and just put the black on endstop signal on the board?

If anyone have a solution I take it

Thx!

jay_s_uk

@Amagatth I run a similar probe almost the same way. I take 12v from another header and then connect ground and the input pin on the endstop header.

Amagatth

@jay_s_uk did you have a photo of your installation plz?

jay_s_uk

@Amagatth here you go

The one on the left is the ground and signal connection, the one on the right take 12v (as thats my system voltage)

Amagatth