Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Update to RRF3 -> password doesn't work anymore

    Scheduled Pinned Locked Moved
    Duet Web Control
    4
    16
    569
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • dc42undefined
      dc42 administrators
      last edited by

      Which version of DWC are you using? Check the Settings General tab.

      Duet WiFi hardware designer and firmware engineer
      Please do not ask me for Duet support via PM or email, use the forum
      http://www.escher3d.com, https://miscsolutions.wordpress.com

      1 Reply Last reply Reply Quote 0
      • CMPundefined
        CMP
        last edited by

        DWC 3.2.0

        1 Reply Last reply Reply Quote 0
        • dc42undefined
          dc42 administrators
          last edited by

          Confirm that you are running the 6HC in standalone mode, not with a Pi attached?

          Duet WiFi hardware designer and firmware engineer
          Please do not ask me for Duet support via PM or email, use the forum
          http://www.escher3d.com, https://miscsolutions.wordpress.com

          1 Reply Last reply Reply Quote 0
          • CMPundefined
            CMP
            last edited by CMP

            No, I'm using it with the Pi. But the Problem was the same with the duet 2 ethernet (but with an older RRF 3 Version)

            The password on the PI and the duet are the same.

            1 Reply Last reply Reply Quote 0
            • Vetiundefined
              Veti
              last edited by

              @CMP said in Update to RRF3 -> password doesn't work anymore:

              Microstepping - X:16(on), Y:16(on), Z:16(on), U:16(on), E:16(on):16(on)

              this means there is an error with your micro stepping command.

              CMPundefined 1 Reply Last reply Reply Quote 0
              • CMPundefined
                CMP @Veti
                last edited by

                @Veti I think thats because I didn't care to write the command for 1/16 step for all steppers since its the default.

                1 Reply Last reply Reply Quote 0
                • Vetiundefined
                  Veti
                  last edited by

                  did you try dc42 suggestion to send the M551 manually?

                  1 Reply Last reply Reply Quote 0
                  • CMPundefined
                    CMP
                    last edited by

                    Yes I did and it didn't work

                    1 Reply Last reply Reply Quote 0
                    • chrishammundefined
                      chrishamm administrators
                      last edited by

                      There is no support for password authentification in SBC mode yet. Since DuetPi + DSF v3.3 will get optional HTTPS support I'll check if I can add it to the next release.

                      To use M551 with v3.2 you must revert to standalone operation for now. If you are using your board(s) in standalone mode and it isn't working, please share your full config.g.

                      Duet software engineer

                      1 Reply Last reply Reply Quote 0
                      • CMPundefined
                        CMP
                        last edited by

                        Thank you for the Information.
                        I'll try it in standalone mode, the next time I get the chance.

                        1 Reply Last reply Reply Quote 0
                        • First post
                          Last post
                        Unless otherwise noted, all forum content is licensed under CC-BY-SA