3HC Documenation
-
I have it set that way I think? Pin one is on and pin 2,3,4 are off. Is that not correct?
-
-
@Work-Horse-XL also the Diag LED just flashes rapidly and never pauses.
-
You're using SBC mode, can you please try updating?
sudo apt update && sudo apt full-upgradeThat looks correct in the photo.
-
Is that where you hook a keyboard,mouse and monitor to the pi and use the tremial window after you put the files on the sd card with DWC? I'm powering the pi with the duet3. Will that work for power? I do not really understand the PI process. I just use it for WIFI on the board.
Thank you for the help.
-
You don't have to connect a keyboard, mouse, monitor to the Pi. You can also use remote terminal software (SSH) to connect to the command line terminal and update it that way.
Powering the Pi from the Duet may work for a Pi3, but is not recommended for a Pi4, or if you have any USB peripherals attached to the Pi.
I suggest you review the getting started guides
https://duet3d.dozuki.com/Wiki/Getting_Started_With_Duet_3
https://duet3d.dozuki.com/Wiki/SBC_Setup_for_Duet_3 -
@Phaedrux I have update the main board to 3.2 and put all the 3HC files in the system folder. There is still no can bus communication to the 3HC board.
-
Did the can bus cable come with the Duet or was it procured separately?
-
@Phaedrux The cable did not come with it but that was the problem. It was bad. I found a 15' cable and hooked it up and it is working now. Wow! what a mess. Thank you for helping me.
-
Glad you got it working.
