Engine does not start.
-
Hello everyone,
I just finished wiring my TEVO LITTLE MONSTER on my DUET WIFI.
Everything seems to be plugging in, because nothing smokes …
I wanted to move my motors using DuetWebControl, but my engines do not move.
What can it happen.
Thank you -
Did you home first?
-
You mean the engine towards the end stop?
-
You have delta printer, so read https://duet3d.com/wiki/Configuring_RepRapFirmware_for_a_Delta_printer. As a safety precaution, the firmware will not let you move the effector until you have homed the printer. Except that you can send special commands to test the motors individually, as described at the end of that wiki page.
-
Thank you it works
