DWC timing out
-
My DWC is acting up again, it keeps timing out, thats the error it gives me anyway. I can be connected and not using the machine and it will sit there for an hour and be fine no errors. a few min into a print and BAM disconnected. I have reset my router to factory and started fresh (it does it less after this) and reloaded my card on the board. are there settings that I need to play with to tweak this? What else can I look for?
-
It's kinda hard to know what firmware you are on or even what kind of board you are running without the info.. M122?
-
=== Diagnostics ===
Used output buffers: 2 of 32 (10 max)
=== Platform ===
Static ram used: 24996
Dynamic ram used: 89628
Recycled dynamic ram: 64
Stack ram used: 1104 current, 3784 maximum
Never used ram: 12600
Last reset 00:40:52 ago, cause: power up
Last software reset code 0x0003, HFSR 0x00000000, CFSR 0x00000000, ICSR 0x00400000, BFAR 0xe000ed38, SP 0xffffffff
Spinning module during software reset: GCodes, available RAM 1024 bytes (slot 3)
Error status: 0
Free file entries: 10
SD card 0 detected, interface speed: 20.0MBytes/sec
SD card longest block write time: 0.0ms
MCU temperature: min 49.4, current 49.7, max 52.0
Supply voltage: min 24.3, current 24.4, max 24.5, under voltage events: 0, over voltage events: 0
Driver 0: standstill
Driver 1: standstill
Driver 2: standstill
Driver 3: standstill
Driver 4: standstill
Date/time: 2017-08-15 20:09:33
Slowest main loop (seconds): 0.004150; fastest: 0.000000
=== Move ===
MaxReps: 0, StepErrors: 0, MaxWait: 0ms, Underruns: 0, 0
Scheduled moves: 0, completed moves: 0
Bed compensation in use: none
Bed probe heights: 0.000 0.000 0.000 0.000 0.000
Probe change coordinates:
=== Heat ===
Bed heater = 0, chamber heater = -1
=== GCodes ===
Segments left: 0
Stack records: 1 allocated, 0 in use
Movement lock held by null
http is idle in state(s) 0
telnet is idle in state(s) 0
file is idle in state(s) 0
serial is idle in state(s) 0
aux is idle in state(s) 0
daemon is idle in state(s) 0
queue is idle in state(s) 0
Code queue is empty.
=== Network ===
State: 4
=== Webserver ===
HTTP sessions: 1 of 8
FTP connections: 0, state 0
Telnet connections: 0, state 0 -
As the M122 report doesn't Inc!ude the firmware version, you must be a few versions out of date. I suggest you start by upgrading to firmware 1.19. Read the important upgrade notes first.
-
I forgot, is that on Github or here?
-
I got it, both are updated now to 1.19
