Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Belt path C-beam

General Discussion

1

1

126

Log in to reply

Falkia last edited by Falkia

The plan was to have the belt going between the wheels inside the C-Beam but with pulley with 20 teeth there is no room. Is there any disadvantage to have the belt connected off center and having the free side of the belt between the wheels (picture 1)?

Another solution is to have the motor, belt and pulleys rotated 90 degrees (picture 2 and 3).

Pic1

Pic2

Pic3
Printer: "Deltacus" Delta with 510mm bed diameter and 925mm build height. Powered by Duet 2 WiFi. Duet Smart Effector with E3D Volcano.
1 Reply Last reply
Reply Quote 1

1 / 1