Bedleveling

[MrBlom]

Hello

Hmm i think did see some where that you can
level the bed with 2 motors
one on each side in the latest firmware

is that so or do i remember wrong ?

if so if i run 2 motors on one each side
i guess each side need a enstop
can then remove the bltouch ?

if this is possible where can read more about it

Thanks

[MrBlom]

found it
https://duet3d.com/wiki/Bed_levelling_using_multiple_independent_Z_motors

[coffman34]

Why not utilize the BLTouch for the leveling? Just add in your bed.g file to probe near each lead screw you want to test for, then it will adjust based on that information.