Tool not showing on DWC

fcwilt

When I enter M98 P"config.g" into the DWC console I get 'Warning: Macro file config.g not found'. Correcting this sounds like it would be helpful for future issues.

I don't know why that would be. I'm using firmware 3.2.2 and that M98 command executes config.g as expected.

You sure you typed the filename correct?

Frederick

resh

@fcwilt When I type M98 P"config.g" into the console box and hit send I get that message. I copy/pasted and got the same thing.

I spoke too soon about that tool working. When I go to retract the entire X axis moves. I put in this line and it moved left. G1 E-20 F300

I figured that should retract 20mm of filament at 300, instead the entire extruder moves left.

fcwilt

@resh said in Tool not showing on DWC:

@fcwilt When I type M98 P"config.g" into the console box and hit send I get that message. I copy/pasted and got the same thing.

Is your config.g file is in the System folder?

I spoke too soon about that tool working. When I go to retract the entire X axis moves. I put in this line and it moved left. G1 E-20 F300

I figured that should retract 20mm of filament at 300, instead the entire extruder moves left.

Post your current config.g file again and let me take a closer look.

Frederick

resh

@fcwilt Changed E0 to E3, I got confused on the numbers but it's working now.

In the system tab my config folder is labeled "config.g.bak". There isn't anything with just config.g

fcwilt

@resh said in Tool not showing on DWC:

@fcwilt Changed E0 to E3, I got confused on the numbers but it's working now.

In the system tab my config folder is labeled "config.g.bak". There isn't anything with just config.g

Curious. I wonder how the board can boot without a config.g file.

Perhaps it is in another folder and the board finds it there, somehow.

Check your Macro folder.

Frederick

SIam

Curious. I wonder how the board can boot without a config.g file.

If no config.g file is found, then the RRF will use the config.g.bak

fcwilt

@siam said in Tool not showing on DWC:

Curious. I wonder how the board can boot without a config.g file.

If no config.g file is found, then the RRF will use the config.g.bak

I've been using Duets for several years and that fact escaped me.

Thanks very much.

Frederick

resh

@siam Will this cause a problem somewhere down the line? I probably did something at some point and made that folder vanish.

fcwilt

@resh said in Tool not showing on DWC:

@siam Will this cause a problem somewhere down the line? I probably did something at some point and made that folder vanish.

Well you can do one of the following:

rename config.g.bak to config.g
create a new config.g and copy the contents of config.g.bak into it.

Frederick

Phaedrux

After renaming config.g please send M98 P"config.g" again.
Also send M122 and report the results of that.