Wifi Suddenly Stopped Working on Duet 3 Mini 5+
-
@jay_s_uk Ran that command and got this back, also is probably worth noting that the wifi module led is not on when I plugged it in via usb to my computer. I'm using CuteCom to connect to it if that matters.
[11:04:58:775] Debugging disabled for modules: Platform(0) Network(1) Webserver(2) GCodes(3) Move(4) Heat(5) DDA(6) Roland(7) Scanner(8) PrintMonitor(9) Storage(10) PortControl(11) DuetExpansion(12) FilamentSensors(13) WiFi(14) Display(15) LinuxInterface(16) CAN(17)␊ ``` -
@3dmakerkid sorry, I missed a bit
M111 P14 S1 -
@jay_s_uk No problem, got this back when I sent
M111 P14 S1[11:10:57:432] Debugging disabled for modules: Platform(0) Network(1) Webserver(2) GCodes(3) Move(4) Heat(5) DDA(6) Roland(7) Scanner(8) PrintMonitor(9) Storage(10) PortControl(11) DuetExpansion(12) FilamentSensors(13) Display(15) LinuxInterface(16) CAN(17)␊ -
@3dmakerkid try and send
M552 S0and thenM552 S1 -
@jay_s_uk Did it and it connected to wifi again.
-
@3dmakerkid well thats a start. Check your config again for M552 S1
-
@jay_s_uk Looks like my entire config.g file is wiped for some reason? Sorry for taking so long to respond, lost the micro sd card for 3 hours.
-
@3dmakerkid Am now using the config.g.bak file, but I'm getting under voltage warnings, even though there is no usb plugged in, it's on 24v power.
-
Is the config.g file there, but empty, or missing entirely?
If you copy the content so config.g.bak into a new config.g file is everything ok now? Is wifi working correctly?
Do you recall saving config.g and rebooting sometime before the wifi dropped?I think the wifi not connecting was just a symptom of the empty config.g since it didn't get the m551 S1 command at startup to enable wifi.
-
@phaedrux It was empty, wifi works fine when I copy everything over into a new config.g file, I did save config.g and reboot right before the wifi dropped. Looks like my psu is dead and not putting out 24V anymore too, completely unrelated though.
