Duet 3 mini 5+ reboot itself during printing
-
Hi, i recently got a problem, my duet 3 mini reboot itself after some minutes of printing.
Also, i have a bit of issue with the usb connector, if i touch a bit the cable end, duet side, it reboots... -
@krohm-koala After a reboot, enter M122 in the console and post the result here
if i touch a bit the cable end, duet side, it reboots...
Please read this:
https://duet3d.dozuki.com/Wiki/USB_ground_loops -
@siam I've already tried without an USB cable connected, it does the same...
-
@krohm-koala said in Duet 3 mini 5+ reboot itself during printing:
@siam I've already tried without an USB cable connected, it does the same...
ok then show us the diagnostic result (M122)
-
@siam i think i've found the problem, i just tried stopping the daemon.g from running and it doesn't rebooted in an hour print... i think i'll have to shut it down during printing and reactivate it after.
