-
@dc42 would that board be ok to use with the spindle drive on my denford novamil and novaturn?
As I understand it the 0-10v floats on my spindle drive at about 110v above controller vref on both machines.
For my previous attempts at controller conversion I ended up turning a pot with a servo. I gave up on that front and reverted to the OEM controller but have been looking for a better onboard controller solution ever since.
If the 1HLC driver beta goes well I'm hoping to convert both my denfords over to Duet with linear scales, so I've started looking into this sort of thing again.
Any thoughts would be much appreciated.
Cheers
Barry M
undefined)
undefined)
