Z Start height too high? Ignores endstop?



  • Hi all, Just got my new duet board setup last night. Prints great but I have a big issue. When I home manually it works fine and stops at the correct Z spot when the endstop is trigggered, but when i start a print it goes up too high, literally pushing the Z endstop farther up the rail (its a corexy design). I can't figure out what is causing this.

    Also, what does the Z baby stepping feature on print status do? I assumed it would move the bed platform down during the print but on my printer it does not do anything
    thanks.


 

Looks like your connection to Duet3D was lost, please wait while we try to reconnect.