Move the z over the 0
-
hi what are the commands to move the z axis over the 0? thank you
-
Please explain what you mean.
-
it turned into home, now i have to adjust z axis. when it's in home position i can't move the axis.
-
My best guess is that you have homed Z so now it is at Z=0 but you want to move the bed closer to the nozzle. Is that correct? Can you confirm that you can move the Z axis in the positive direction but not the negative.
-
If you can't move the nozzle either up or down, you may have your M208 settings in config.g set incorrectly.
