Corexy origin change...?
-
Hi,
I am used to a Delta printer, where the origin (X=0 and Y=0), was located in the center of the bed.
With the new printer, the origin is a corner of the bed.
I would like to change it, so I have been reading is possible, the biggest doubt I have if the gcode M557, where the grid is defined for the Mesh compensation, supports negative values.
Someone uses, in a Cartesian or corexy printer, the center of the bed as the origin (x=0 a y=0)?
What things o must have in account for define center of bed as origin?
-
You can make it the center as well.
