Bed Heating too slow
-
Hi I have a problem with my prusa bed. I keep tuning it and it keeps throwing me heater fault, heating too slow. I know the bed is ok because it heats up fine during tuning M303, but during print it just throws the error and shuts off for good. vin is 24v strong and all terminals are properly crimped with feral connectors. how can I make thermal runaway less aggressive.
-
What firmware version are you using?
What temp did you tune to?
What values did it provide?
After tuning did you save the resulting values either with M500 to save it to config-override.g and M501 at the end of config.g to load those values, or manually enter the values in config.g?
-
@phaedrux v3.4.1 I think. I copy and paste them inside config, I don't like 2 config files. I'm OCD like that lol. i stumbled on M570 Im about to test some stuff.
-
@phaedrux well damn i see what is happening there are pre saved values in config-override.g, it is doing what it should overriding my config.
-
undefined Phaedrux marked this topic as a question
-
undefined Phaedrux has marked this topic as solved
