Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Resetting the 3d printer while printing

Duet Hardware and wiring

3

22

821

Log in to reply

undefined

dc42 administrators @Kevvv
last edited by

@kevvv before you return your board, please disconnect the bed heater from it, then power up and check whether the bed heater LED still turns on immediately. If it does then return the board for replacement. If it doesn't then you have a short circuit between your bed heater and ground.
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com
undefined 1 Reply Last reply
Reply Quote 0
undefined

Kevvv @dc42
last edited by

@dc42
![alt text]( image url)

Led is always on.
1 Reply Last reply
Reply Quote 0

1
2

2 / 2