error G0\G1 home Z ratrig vcore 500

Rushmere3D

@dejvid17 It also appears your max hotend temp is 250, with a requested 248 you overshoot is probably causing the fault.

dejvid17

@rushmere3d

Rushmere3D

@dejvid17 Right there you see, you don't have a compatible start or end gcode, it's set up to use klipper and macros.

dejvid17

@rushmere3d
Do you know where I can find right config superslicer?
I've been tring few option but results the same

Warning: Macro file pause.g not found

Error: Bad command: START_PRINT EXTRUDER_TEMP=225 BED_TEMP=75
Error: Bad command: SET_GCODE_OFFSET Z=0
Error: Bad command: SET_PRESSURE_ADVANCE ADVANCE=0.05

Rushmere3D

@dejvid17 If you know or can message another ratrig Duet user they might be able to help? But and I mean no disrespect, you need to learn this stuff. Read the duet documentation site there is a whole section for gcode commands. What you looking for are the commands to set a extruder and bed temp, as well as to home the printer and then perform a bed level. Gcode reference: https://docs.duet3d.com/en/User_manual/Reference/Gcodes

You also need to pay attention to what the console is telling you, you don't have a pause.g so you need to create one.

The commands are wrong, which I've already told you so it's not going to work until this is changed.

I and others can give you the information but if you don't understand it you'll not be able to fix or change stuff later.

Rushmere3D

@dejvid17

You "could" use this for example

Start gcode

G90 ; use absolute coordinates

M83 ; extruder relative mode

M104 S[first_layer_temperature] ; set extruder temp

M140 S[first_layer_bed_temperature] ; set bed temp

M190 S[first_layer_bed_temperature] ; wait for bed temp

M109 S[first_layer_temperature] ; wait for extruder temp

G28 ; home all

G29 S0 ; run mesh

End gcode

M104 S0 ; turn off temperature

M140 S0 ; turn off heatbed

M107 ; turn off fan

{if layer_z < max_print_height}G1 Z{z_offset+min(layer_z+10, max_print_height)} F600{endif} ; Move print head up

G1 X5 Y5 F2000 ; present print

M84 X Y E ; disable motors

Rushmere3D

Of course I'm assuming you've set up homing files, bed leveling files and that you've test things individually before just going head on with a first print?

dejvid17

@rushmere3d
I know.. I should start from learning gcode commands but I thought it will be much easier..

Rushmere3D

@dejvid17 So did you get it working?

dejvid17

@rushmere3d
At this moment I have problem with printing. Filament move after extruder and after few sec is a one big ball