I connect two wire switch ( normal close) to the duet wifi X stop 3v3, GND ,
and I see reaction on my board reset right way.
my question :- my duet board good or bad ? how to I check it work properly my board after I connect Limit Switch .
elmoret last edited by
Sounds like you've connected it to 3.3v and GND, instead of signal and GND.
Connecting to 3.3v and GND shorts the board, hopefully you haven't damaged it! Would recommend reading the wiki:
how do I know my board damaged ?
number40fan last edited by
Connect it correctly and see if it works.
try G1 x200 f1000 s1 , it work x axis stop right way . aging thanks for replay everyone