Duet3D Logo

    Duet3D
    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    X stop

    General Discussion
    3
    5
    469
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • patel
      patel last edited by

      I connect two wire switch ( normal close) to the duet wifi X stop 3v3, GND ,
      and I see reaction on my board reset right way.
      my question :- my duet board good or bad ? how to I check it work properly my board after I connect Limit Switch .

      1 Reply Last reply Reply Quote 0
      • elmoret
        elmoret last edited by

        Sounds like you've connected it to 3.3v and GND, instead of signal and GND.

        Connecting to 3.3v and GND shorts the board, hopefully you haven't damaged it! Would recommend reading the wiki:

        https://www.duet3d.com/wiki/Connecting_endstop_switches

        1 Reply Last reply Reply Quote 0
        • patel
          patel last edited by

          how do I know my board damaged ?

          1 Reply Last reply Reply Quote 0
          • number40fan
            number40fan last edited by

            Connect it correctly and see if it works.

            1 Reply Last reply Reply Quote 0
            • patel
              patel last edited by

              try G1 x200 f1000 s1 , it work x axis stop right way . aging thanks for replay everyone

              1 Reply Last reply Reply Quote 0
              • First post
                Last post
              Unless otherwise noted, all forum content is licensed under CC-BY-SA