wiring CAN toolboard v1.1 to 6HC board
-
according to this for 1.1 tool board I have to wire only 2 wires for CAN and solder termination pads on the back. Is this correct?
Muldex IDEX Duet2+Duex5
Custom CoreXY 600x400 Hemera , Duet3+Toolboard+1HCL closed loop
Sapphire Pro with Duet2, with closed-loop motors
custom high temp E3D tool changer with Duet2+Duex -
@martin7404 That's what I just followed wiring up my v1.2 toolboard to my 6HC and it worked fine.
-
@martin7404 that's correct, if the tool board will be the last (or only) CAN-connected board on the bus.
