Trouble setting up power recover, no ressurect.g file created

claustro

I am having very basic problem during setup or resume after power failure
I can't find a powerfail.g file after power loss.

this is my config files on firmware 1.19 I am running a 24V system with 2 PSU one for bed and one for elettronics on a CoreXY printer

sys/powerfail.g

G91
G1 Z3 F3000
M83
G1 E-4 F3600

sys/powerrestore.g```
[[language]]
M83
G1 E4 F3600

sys/resurrect-prologue.g

[[language]]
M116
G28
M83
G1 E2 F3600

sys/config.g

[[language]]
M911 S12.0:19.5:22.0

dc42

The power fail handling works much better in the 1.20beta series, so I suggest you upgrade to 1.20beta11. Note, the powerfail.g file is no longer used and the M911 command format is changed.

claustro

ok time to update

claustro

I updated to 1.20 and now the resurrect.g file was created

my resurrect.g

[[language]]
; File "0:/gcodes/vase mode20mm_calibration_cube.gcode" resume print after print paused at 2017-12-01 23:43
M140 S60.0
G10 P0 S205 R0
T0 P0
G29 S1
M98 Presurrect-prologue.g
M106 P0 S0.00
M106 P2 S0.00
M106 P3 S0.00
M106 P4 S0.00
M106 P5 S0.00
M106 P6 S0.00
M106 P7 S0.00
M106 P8 S0.00
M106 S0.00
M116
M290 S0.000
G92 E391.75861
M82
M23 0:/gcodes/vase mode20mm_calibration_cube.gcode
M26 S19664 P0.000
G0 F6000 Z2.180
G0 F6000 X80.61 Y143.44
G0 F6000 Z0.180
G1 F1200.0 P0
M24

Now i have trouble understanding how to make the bed calibration after resume.
I am using a bl-touch for bed levelling.

my bed.g

[[language]]
G91
G1 Z6 F200
G90
M98 Pdeployprobe.g
;M557 X30:270 Y30:270 S60  Buono 
M557 X100:200 Y100:200 S50
G29
M98 Pretractprobe.g

If I understand correctly I could make 4 sampling at the very corner of the bed raising the Z above the printed part before sampling . but I really don't know how achieve it .
I have a corexy printer with 300x300 bed

dc42

The height map that you used during the print will be loaded automatically by the resurrect.g file (it uses G29 S2). So all you really need to do is to set an accurate Z height when you resume the print. You can do this by moving the head to one of the corners, lowering it to about 5mm above the bed, then executing G30. If there is a bed height error at that corner, you can use an H parameter on the G30 command to correct for it.