Use 2 Duet3 Roto TB

[Edkirk]

Re: Duet3D announces new tool board at FormNext Is it possible to use two different Roto TBs on one system? I thought I read somewhere that there wasn't support for 2 or more of the Roto TB on the same system. If so where do I fine supporting documentation? Thanks, Ed

[oliof]

@Edkirk you can change the CAN address of the tool board to use multiple in okne system. Ease of wiring can be achieved by using a tool distribution board.

[dc42]

@Edkirk as @oliof says you can use more than one Roto toolboard in a system if you change their CAN addresses, which is done using M952.

[Edkirk]

This post is deleted!