Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Implementing Klipper through SBC on 6XD

    Scheduled Pinned Locked Moved
    General Discussion
    2
    2
    91
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Omer1015undefined
      Omer1015
      last edited by

      I've been trying to connect Klipper as an SBC to a Duet 3 MB6XD board but have encountered several issues. I have a Raspberry Pi 4 running Klipper connected to the Duet 3 MB6XD and am using Mainsail as a web interface. Following the instructions from the Klipper GitHub (https://github.com/Klipper3d/klipper/blob/master/config/generic-duet3-6xd.cfg) for the generic Duet 3 6XD configuration and flashing the firmware for the SAME70Q20B processor, which is also used on the 6HC, I kept receiving errors indicating that Moonraker couldn't connect to the processor or that no devices were connected to /dev/serial/by-id/*. I repeatedly reflashed the Raspberry Pi 4 OS and followed the instructions until, randomly, it worked once when I set the communication interface to USB instead of Serial. However, even when it appeared to be connected to the 6XD board and no errors showed up, moving the motors and connecting sensors didn't work.

      jay_s_ukundefined 1 Reply Last reply Reply Quote 0
      • jay_s_ukundefined
        jay_s_uk @Omer1015
        last edited by

        @Omer1015 you won't get any klipper support here. You're best off heading over to discord and seeking support there

        Owns various duet boards and is the main wiki maintainer for the Teamgloomy LPC/STM32 port of RRF. Assume I'm running whatever the latest beta/stable build is

        1 Reply Last reply Reply Quote 0
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA