Many problems with 3.5.2

3DOeste

Hi, I'm sure DWC was on 3.5.2, and also try again from 3.5.1 to 3.5.2 and I have the slow response from commands from panel due (and also from DWC), back to 3.5.1 again and everithing runs fine.

droftarts

@3DOeste A suggestion from @chrishamm is to update to 3.5.2 and disconnect the PanelDue, and see if that makes a difference to the responsiveness of DWC. How is the PanelDue connected? By 4-wire cable, ribbon cable, or both?

Ian

3DOeste

It's connected with a 4-wire cable. I'll test disconnecting the PanelDue as soon as the current print is finished.

dc42

@3DOeste instead of disconnecting the PanelDue it is sufficient to leave it displaying its Setup page.

3DOeste

@dc42 Hi, I tried that, and it works ok. Today I installed 3.5.3, same behaviour as 3.5.2, but if after homing, I enter the panel due setup page, and then back to status, everything works as it should, without weird delays. It doesn't happen with 3.5.1.

dc42

@3DOeste thanks for the feedback. We added a check in 3.5.2 to reduce the chance of consistently running our of buffers when both PanelDue and DWC are active. It appears that this check is having a side-effect in your system. I have created this issue https://github.com/Duet3D/RepRapFirmware/issues/1047.

dc42 created this issue in Duet3D/RepRapFirmware

open Startup issues when PanelDue and DWC are both active #1047

AlexKid

Looks and sounds like the same issue I have.
https://forum.duet3d.com/topic/36643/randomly-reconnect-of-dwc-on-duet2-ethernet?_=1727016238232 isn't it? Started with 3.5.2 and also present with 3.5.3.

T3P3Tony

@3DOeste please would you test this with 3.6beta3 RRF and 3.5.1 Paneldue firmware:

https://forum.duet3d.com/topic/37289/software-version-3-6-0-beta-3-now-available
https://forum.duet3d.com/topic/37179/paneldue-firmware-3-5-1-released

these together should have resolved this issue.

3DOeste

@T3P3Tony Hi Tony, I tried but 3.6beta3 wroke connection with DWC, I'm trying to fix it now.

droftarts

@3DOeste There's a bug with 3.6.0-beta.3 on Duet Ethernet boards. See https://forum.duet3d.com/post/350049 for updated version.

Ian

T3P3Tony

@3DOeste I was not sure ,from the other thread, if this is also fixed for you?