I think the bed compensation can take the printer outside it limits
Perplexed last edited by
I was playing around with the z probe and built a mount that sits 30mm from the nozzle. When I added the probe offset in G31 and ran the bed compensation my nozzle collided with the fixation of the bed. I had the coordinate at Y15 so my nozzle hit the nut at Y-15.
It might be good to look in to how that function is handled. The Mesh Comp removes the non accessible points.
Users sometimes need to probe outside the normal limits - for example on delta printers - so we trust you to set the probe points correctly. I'll add a note about this in the wiki.