WiFi reported error: no known networks found

Quadcells

Hello,
I am following the steps from here: https://betrue3d.dk/duet-wifi-getting-started/#dlinstall
but when trying to enable the wifi I get this:

M552 S1
SENDING:M552 S1
WiFi reported error: no known networks found
Wifi module is idle

What am I doing wrong?

/quadcells

dc42

I assume you are running firmware 1.19 or later. Send M587 with no parameters to the Duet, then check that the network(s) it lists is/are the one(s) you told it about, and that the SSID is exactly right. SSIDs are case-sensitive.

Quadcells

Thanks for the reply.
Did I miss a step?
M587 returns:
Remembered networks:
TNCAP2FCC19

Well I missed something.

I did not setup any networks for the DuetWifi.
I guess I need to configure the Firmware configuration file.

I should state that this is a new board DuetWifi 1.03.
I tore down my Delta that I built but never was able to printed with it.
I decided to replace my controller with a DuetWifi.
Been reading so much in what little spare time I have to understand the Duet hardware and the Reprap firmware.
Still learning.

/quadcells

dc42

See https://duet3d.dozuki.com/Guide/1.%29+Getting+Connected+to+your+Duet/7.

Quadcells

Thank you, looking it over now

Quadcells

dc42,
Thanks for pointing out that guide to me. It has helped me a ton.

/quadcells