Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    Z endstop not homing

    Duet Hardware and wiring
    2
    3
    419
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • snakeibf
      snakeibf last edited by

      I am having an issue withe the Z motor continuing to lower the extruder even after the homing switch is triggered. The X and Y axes home properly and stop as they should.
      I have them all set as active low and in the web interface It even shows the endstop is active when triggered. It just continues to move down anyway. I'm sure I have the correct one connected as I activated all three just to be sure. Has anyone else had this issue?

      1 Reply Last reply Reply Quote 0
      • dc42
        dc42 administrators last edited by

        Have you seen #1 in the FAQ at https://duet3d.dozuki.com/Wiki/FAQ ?

        Duet WiFi hardware designer and firmware engineer
        Please do not ask me for Duet support via PM or email, use the forum
        http://www.escher3d.com, https://miscsolutions.wordpress.com

        1 Reply Last reply Reply Quote 0
        • snakeibf
          snakeibf last edited by

          Got it all sorted, thank you for the link.

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA