Auto tune cancelled because target temperature was not reached

Phaedrux

Do you have a silicone sock or any other type of thermal insulation installed? Is your part cooling fan blowing on the block?

carlosspr

I understand you are triying to auto tune the PID. Which P value are you using for M301 command?. Try increasing it to ramp up the heating curve, until you get a good result without overshoot warnings.

TraneMan

This is what is in the heater section of my Config.g file ; Thermistors and heaters
;*** You can use S and B parameters to define the parameters of the thermistors you are using
M305 P0 T100000 B4388 R4700 H0 L0 ; Put your own H and/or L values here to set the bed thermistor ADC correction
M305 P1 T100000 B4725 R4700 H0 L0 ; Put your own H and/or L values here to set the first nozzle thermistor ADC correction
M305 P2 T100000 B3974 R4700 H0 L0 ; Put your own H and/or L values here to set the second nozzle thermistor ADC correction
M301 H1 P10 I0.10 D100 T0.50 S1.5 ; PID settings for extruder 0
M301 H2 P10 I0.10 D100 T0.50 S1.0 ; PID settings for extruder 1
M570 S12000 ; Increase to allow extra heating time if needed
M307 H0 A199.0 C962.6 D4.5 B0
M307 H1 A406.3 C166.4 D10.3 B0

TraneMan

@phaedrux I do have a sock on it and no part cooling fan yet

dc42

What is the exact M303 command you are sending to tune the heater, and which firmware version are you using?

TraneMan

M303 H1 S240 Firmware version is 1.20

TraneMan

Sorry I didn't type that correctly.
M303 H1 P1 S240

dc42

Can your hot end actually reach 240C? It sounds to me that it can't. This is odd because the heater power should be 35W, which should be plenty especially with a silicone sock. What does the temperature graph look like when you try to auto tune?

TraneMan

dc42

Either it's not running at full PWM, or the heater power is very much lower than it should be, or your thermistor is under-reading by a large amount.

I see an error in your thermistor configuration:

M305 P1 T100000 B4725 R4700 H0 L0 ; Put your own H and/or L values here to set the first nozzle thermistor ADC correction

You have used B4725, which is correct for the Semitec GT104-2 thermistor only if you also add the C7.060000e-8 parameter. See https://e3d-online.dozuki.com/Guide/V6+RepRap+Firmware+Configuration/26?lang=en.

TraneMan

@dc42 Thank you for catching that I corrected M305.
I found the cause of my problem, the heat block was tight against the heatsink. I went back and looked at the Titan Aero assembly instructions and saw a picture of it ( Thank God for pictures).

They should put something in their instructions for dummies like me.

Everything auto tuned perfectly and have it set up in the firmware.

Now on to the rest of the setup, Thanks for being here for us newby's