Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    Problem with Panel Due (blank screen) order #2803

    PanelDue
    2
    5
    470
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • florentmarulaz
      florentmarulaz last edited by

      Good morning,
      When I connect my PanelDue to my Duet3d Wifi, it only displays a blank screen (except for a few barely visible vertical lines).
      After firmware update, the problem persists, and my screen is apparently down...
      What can you do to help me, or to exchange defective equipment (in my opinion)
      Sincerely: Florent MARULAZ

      T3P3Tony 1 Reply Last reply Reply Quote 0
      • T3P3Tony
        T3P3Tony administrators @florentmarulaz last edited by

        @florentmarulaz hi Florent, thanks for the post. Did this happen from the first time you plugged it in? Can you try powering the PanelDue, with the screen plugged into it, from the USB port.

        Cheers

        Tony

        www.duet3d.com

        1 Reply Last reply Reply Quote 0
        • florentmarulaz
          florentmarulaz last edited by

          Hello Tony,
          First of all, thank you for answering me so quickly.
          Then, indeed, this problem appeared as of the first connection, via USB.
          I thought at the time (in February) that it was due to a too weak power supply through the USB port.
          I postponed the insatallation of the Duet and the PaneDue until later; because I was too busy at the beginning of the year.
          I restarted my 3d printer project with DuetWifi this week. And there, by connecting the PanelDue: blank screen.
          I updated the firmware by scrupulously respecting the procedures(PanelDue-5.0i-7.0i.bin) and the problem remains whole, in USB or on the DuetWifi card...
          So I'm at a dead end...
          Sincerely: Florent

          T3P3Tony 1 Reply Last reply Reply Quote 0
          • T3P3Tony
            T3P3Tony administrators @florentmarulaz last edited by

            @florentmarulaz this is with the Duet powered by 12V/24V ? If so then I think we need to replace this under warranty. I will send you an email as you bought it directly from us.

            www.duet3d.com

            1 Reply Last reply Reply Quote 0
            • florentmarulaz
              florentmarulaz last edited by

              My Duet is 24v powered..
              Thank's for your help !

              Florent

              1 Reply Last reply Reply Quote 0
              • First post
                Last post
              Unless otherwise noted, all forum content is licensed under CC-BY-SA