mm/s vs mm/min
-
I tried to set 0 too
-
Oh that's too bad. I haven't looked at the newest version yet. I know they were adding some printer profile stuff. I wonder if there is a feature request open already to better support reprapfirmware.
-
@fma I just tried 1.41 and I can't seem to get it to generate the values like you describe.
Is there some checkbox I'm missing to get it to do this?
-
Ok, I found it generates these lines if you use 'Marlin' flavor G-Codes (maybe with others, but I didn't try). No generation with RepRap/Sprinter.
BTW, Slic3rPE estimated the print to 3h, and it took 4h!
Frédéric
-
Ah, that makes sense.
-
@fma said in mm/s vs mm/min:
Ok, I found it generates these lines if you use 'Marlin' flavor G-Codes (maybe with others, but I didn't try). No generation with RepRap/Sprinter.
BTW, Slic3rPE estimated the print to 3h, and it took 4h!
Have you tried running it in simulation mode?
-
Nope... I will do that.
-
@fma said in mm/s vs mm/min:
Slic3rPE estimated the print to 3h, and it took 4h!
I've found that when I have the speed, acceleration, and jerk settings set to match the firmware the estimate is usually within 15 minutes of actual print time. Same with Cura.
-
@fma awesome, this works. I was removing the lines manually for the first two i did but figured i would look it up. Thanks for figuring it out
-
Firmware 2.02RC3 supports the use of M205 to set jerk, in mm/sec.
