Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Homes fine but Y axis acts crazy when trying to move manual

Duet Hardware and wiring

2

2

260

Log in to reply

Wild Bill Diamond last edited by

Homes perfect all axis, manually X works perfect, Z works perfect, Y won't do any thing at all but chatter. Printer is setup as a CoreXY. Any ideas whats causing this?
1 Reply Last reply
Reply Quote 0
Scachi @Wild Bill Diamond last edited by Scachi

@wild-bill-diamond
That sounds like wrong polarity or a bad crimped contact / wire.
Check the wires/contacts/connections to your Y stepper with a multimeter
1 Reply Last reply
Reply Quote 0

1 / 1