Mesh points not reported in console or log.txt

[gnydick]

I reported this a long time ago, but can't seem to find the old post. We're talking somewhere around July, August, maybe. Anyway, I'm on the latest firmware, and running a mesh leveling and it's not printing out anywhere, it'd be nice to have a log of what it detected. It used to do it.

[dc42]

You can get that information in two ways;

1. Display the height map in DWC, then you can hover over the points and ti will tell you the heights.
2. Download the heightmap.csv file.

[gnydick]

@dc42 I know, but it used to show up in the console. It's one of those things that helps. If I were mapping and I saw the values were quite far apart, I might want to cancel it and readjust the bed, especially if I have many probing points.

[dc42]

AFAIR, the points have never been reported when running mesh bed compensation. The old style 3-, 4- and 5-point bed compensation did display the measured heights.

[gnydick]

@dc42 I don't know where else I would have experienced it, seeing 3 digit decimals where the machine control screen only shows 2.

[Phaedrux]

@gnydick G30 S-1 to measure the z probe offset perhaps?

[gnydick]

@phaedrux maybe.