Part Fan Value Missing
The current part fan percentage is not registering on my Panel Due - stuck at 0 percent reading. DWC reads correctly. Ethernet ver 2.02a // DWC 2.0.0 RC3.
Which version of PanelDue Firmware are you running? Look on the Setup page of PanelDue to find out.
Installed latest version 1.22.1 and still no joy. A little more info for you.
1 - The PanelDue fan reading stays at zero percent forever, EXCEPT
2 - If I manually kick the tool fan up or down the PanelDue reading changes to reflect the new DWC value.
3 - The value of the last reading remains unchanged even with a g-code commanded change (DWC reads the new fan correctly).
It's working correctly for me. I am using fan 0 as the print cooling fan. Are you using a different fan number, by using the F parameter in the M563 tool creation command?
EDIT: I just tried using the F parameter to map the fan, and PanelDue still displayed the value that I set in DWC.
Perhaps I didn't state the problem clearly or correctly so I'll try again
1 - I also use fan 0 for the part fan
2 - If , using the DWC Status tab speed slider to set a fan speed, the value reports correctly on PanelDue.
3 - BUT if , for example, I send M106 S255 P0 from DWC ( or from a g-code file ) the PanelDue does NOT report the new value but the DWC displays the new, correct fan speed.
4 - To ensure the setup is correct I sent M563 F0