My Maestro Menu Files are now on github
3dmntbighker last edited by
@dc42 Files whose names begin with "." are suppressed in DWC as you have confirmed, but are displayed by the Maestro's menu system "files" command on the 12864 lcd. I have just tested and confirmed this. (Latest firmware, latest DWC etc.)
Now I understand! I thought you were saying that files beginning with '.' in the /menu folder were showing up in DWC.
I've made a code change to hide filenames beginning with '.' in the 12864 files display. This will be released in the 2.03beta firmware.
v1.6 is now on github,
here are the release notes:
As I no longer need a blank line at the bottom of the main page for M117 messages (Now using M291 messages). I was able to use that real estate to give the existing layout some extra elbow room in the vertical direction. If you do have any M117 message strings (e.g. M117 "Print Started" in your slicer's start G code section) you should change them to use M291 (e.g. M291 P"Print Started") if you want them to display on the 12864
Additionally, I was made aware that without a license assigned to this project, technically no-one should use it. I think that the unlicense is the most liberal available and the most appropriate for the intent behind providing these menu files.
v1.7 now on Github
After a recent print went wrong and crashed the BLTouch bending the pin, I realised I had no way of manipulating the probe while I was standing at the printer. I've added the ability to extend, retract, test, and reset the probe from this new menu. It is accessed from the CTRL (Control) menu.
Veti last edited by
Regarding the license. You might consider the WTFPL
@veti lol, if I'd seen that before I attached the unlicense, I might have.
I've updated a couple of the 12864 menu files to cope with the changes in 2.03RC1
As usual they are in https://github.com/mudcruzr/Duet-Maestro-12864-Menu-Files
2 Files required updates to cope with the changes in 2.03RC1
The new files are main_for_203RC1 and heat_for_203RC1
Upload the 2 new files, rename the existing heat and main to something like heat_backup and main_backup then rename the 2 new files to heat and main respectively.
Note these files are ONLY for using with 2.03RC1
sinned6915 last edited by
THANK YOU for making the files available!
I am using them on LPC1768 port on a ReArm with RRD full graphic LCD.
No network as of yet, and Octoprint is not playing nice with LPC port. LCD is the only way to print.
I changed leveling menu because I don't use BLTouch, but all of the others seem to work well.
Thanks again for your work and for sharing.
bearer last edited by
Thanks for sharing, this is great.
I wonder would it it not be a good resource to link to from the wiki?
I wouldn't have an issue with that but I guess it'd be up to @dc42