G32 problems, adjusting the wrong way

[Haggan90]

@dc42 I just can't get this to work.. it refuses to calibrate the last stepper in the right way.
It seems like it's working for 2/3 steppers.
This is my last 3 results:

21:11:40G32
Leadscrew adjustments made: 1.081 1.187 -3.137, points used 3, deviation before 1.541 after 0.000
21:07:11G32
Leadscrew adjustments made: 1.447 1.558 -2.405, points used 3, deviation before 1.336 after 0.000
21:06:49G32
Leadscrew adjustments made: 2.048 2.189 -1.888, points used 3, deviation before 1.492 after 0.000

[Haggan90]

doesn't anyone have any ideas what's wrong here? =/

[dc42]

Which firmware version are you using? I have 2 reports that this function is broken in the 2.03beta1 release.

[Haggan90]

@dc42 Yes I'm using the 2.03 Beta, the newest firmware.

[Phaedrux]

@haggan90 Roll back to 2.02 for now.

[Haggan90]

@phaedrux I can't, my whole printer is built on the new matrix system

[Phaedrux]

@haggan90 I think we've come to what they call an impasse.

[dc42]

Yes, you'll have to wait until I fix it next week in beta 2.

[Haggan90]

@dc42 ok thank you

[ToWi1989]

I know this is an old topic, but I'm running into exactly the same issue. Did you find a solution to this??

My bad, it turns out my coordinates for the leadscrews were way off, I honestly don't even know what I was doing!